2-5-7-10 Box
Create party favors with just one sheet of cardstock, some scored lines, and some adhesive.
Template
Directions
- Place your 21 x 28cm piece of Sahara Sand CS horizontally on the scoring board and score at 2″, 5″, 7″ & 10″
- Turn your cardstock portrait and score at 2″ & 7″
- Hold your cardstock horizontally with the 2″ section at the top, use paper snips to cut off all but one 2″ tall section from the top of the cardstock as shown in the template below. This will be the flap closure for the box
- Make vertical cuts at the bottom along the score line as shown in the diagram below, and cut off the narrow piece. This will be the bottom of the box
- Create a boarder along the 2″ flap using the scallop boarder punch
- Use a bone folder and crease along all scored lines to shape the box
- Apply sticky strip to the small tab on the side, remove the red liner, and carefully construct the box
- Fold the small flaps towards the center of the box, the large flap over the small flaps
- Apply sticky strip to the outside edge of the large flap under what will be the box front, remove the red liner tape, and apply pressure to finish the bottom of the box
- Punch two holes in flap with 1/8″ handheld punch
- Pull flap down to close box and use a pencil to mark where holes where punched, using the 1/8″ punch, punch holes at the markings
- Thread ribbon through the holes on box, center the ribbon, to close the box, thread ribbon through the holes that were punched through the flap, pull to tighten and tie a bow
- Stamp image from “Flower Shop” in Lost Lagoon ink randomly on a piece of 6.8 x 6.8cm Whisper White CS, stamp the same image again in the spaces with Hello Honey Classic ink, and finally with Tangelo Twist Classic Ink
- Stamp your greeting in the bottom right hand corner using Black StazOn ink
- Stick the stamped 6.8 x 6.8cm Whisper White CS to the 7.2 x 7.2cm piece of Tangelo Twist CS.
- Stick the matted image to the box front using stampin’ dimentionals. You’re Done!
