Thankyou

Today’s card features our Chevron Boarder Punch and Moonlight Designer Series Paper Stacks and the directions can be found below

Lots of Thanks, Chevron Boarder Punch

 

Directions:

    1. Fold 15 x 21cm Blackberry Bliss CS in half, with a bone folder, creating a 15 x 10.5cm card base.  Set aside for a moment
    2. Make a pencil mark on the underside of the Chevron Boarder punch, along the impression line of the punch using a pencil and a ruler
    3. Slide the 9.4 x 13.8cm piece of Whisper White CS into the Chervon punch, Align the right edge of the CS with the right pencil line you drew and punch.  Rotate the CS 180 degrees. Slide the 9.4 x 13.8cm piece of Whisper White CS into the Chevron punch.  Align the right edge of the CS with the right pencil line you drew and punch.
    4. Lay the 9.4 x 13.8cm piece of Whisper White CS on your work surface with the back side of it face up.  (You want the chevrons to be in the top left corner and the bottom right corner.) Stick a scrap piece of Moonlight DP to the Whisper White CS directly over the bottom right hand chevron, making sure that the DP isn’t covering any other open chevrons, using Tombow Liquid glue.  Repeat this process until all six chevrons are covered.
    5. Stamp the greeting in the center of the Whisper White CS using Jet Black StazOn ink
    6. Center and stick the piece of Whisper White CS to the 14.2 x 9.7cm piece of Basic Grey CS
    7. Center and stick the Whisper White Mat to the cardbase using double sided adhesive.  You’re Done!

kristycoromandelsignature

 

Similar Posts

One Comment

Leave a Reply

Your email address will not be published. Required fields are marked *